Fibaro Zwave Plus Water and Temperature Sensor
- Product Information
The Fibaro FGFS-101-ZW5 is a ZWave Plus combination water leak sensor and temperature sensor with built in visual indicator and audio alarm. It has a beuautiful slim design and it even floats. It can work with Zwave and ZWave Plus hubs.
- Detects water leaks with unique telescoping self leveling legs
- Built in temperature sensor
- Optional external wired probe
- Wired output can be tied to an alarm or dialer
- Battery powered, supports wired power
- Built in alarm and visual indicator
The Fibaro water and temperature detector can be set to operate in dual mode to detector water and temperature or in temperature only mode where it is more practical to report room temperature or floor temperature for floor heating systems.
The built in water detecting legs are telescoping and self leveling so they work even on uneven surfaces or small ridges. Or you can add an external probe wire (not included).
It can be connected to a wired alarm system or dialer using the on board NC (normally closed) output terminals.
The sensor is normally battery powered or can be powered by an optional power supply.
Fibaro FGFS-101-ZW5 Water Flood and Temperature Sensor Features:
- Zwave Plus enabled, also supports standard ZWave
- Dual mode water and temperature sensor (can be set for temp only)
- Built-in self adjusting self leveling gold plated probes
- Tilt and case tamper sensors
- Connection terminals for external probe (not included)
- Connection terminals for alarm (NC) and tamper (NC)
- Visual indicator light
- Built in siren
- Powered by CR123A battery (included) or optional 12 or 24VDC power supply (not included)
- Battery lasts up to 2.5 years
- Supports OTA wireless firmware updates (hub must support OTA)
- Built in ZWave range tester when used with Fibaro Homecenter
- Measured temperature range -20C to 100C
- ZWave 908.4 MHz
- Dimensions: 72 x 28mm